Product Description
Rage® Ultra is the world’s best sanding body filler. Its unparalleled sanding qualities are a result of the patented EcoResin™. Its non-sag formula has excellent filling properties, while eliminating the need for finishing putty. Rage® Ultra is part of the Metalworks® system.
APPROVED SUBSTRATES: ▪ Steel ▪ Stainless Steel ▪ SMC ▪ Fiberglass ▪ Galvanized Steel ▪ Aluminum ▪ *Sanded OEM Paint ▪ Silicon Bronze Welds
PREPARATION: • Clean and degrease the entire panel to be repaired with soap and water, followed by a mild cleaning solvent. Thoroughly dry the surface before repairing. • Keep the repair area small. Use 80-180 grit to remove the paint and featheredge with 180. NOTE: Smaller repairs on OEM Paint can be prepared with 180 grit MIXING: • Stir the filler before using. Knead the cream hardener. • Measure hardener 2% by weight (add a ribbon of cream hardener from edge to edge across the center of a 4” diameter puddle). • Puddles larger than 4” (10 cm) in diameter will require additional hardener. Mix thoroughly until uniform color is achieved.
APPLICATION: FINISH: • Apply in layers with even firm pressure. • Do not apply all at once. • Sand body filler with 80-180 grit sandpaper. • If necessary, re-apply Rage® Ultra to fill any pinholes or low spots, allow filler to dry and then sand with 180 grit sandpaper. • Finish sand with 180 grit. * Allow minimum of 20 minutes sanding time over silicon bronze welds. NOTE: For optimum performance apply 440 Express before applying primer surfacer.
