Product Description
Z-GRIP GLAZE® is a two-part, flowable, polyester finishing putty ideally suited for filling and skim coating body work, pinholes, grind marks, low spots and other surface imperfections. Can also be used to fill minor body damage up to 1/8” (3 mm) in depth.
Cream hardener included
PRODUCT: Z-GRIP GLAZE® PART NUMBER: 100482 30 oz. Pumptainer Packaged with Blue Cream Hardener
DESCRIPTION: Z-GRIP GLAZE® is a two-part, flowable, polyester finishing putty ideally suited for filling and skim coating body work, pinholes, grind marks, low spots and other surface imperfections. Can also be used to fill minor body damage up to 1/8” (3 mm) in depth.
APPROVED SUBSTRATES: ▪ Sanded Body Filler ▪ Steel ▪ Fiberglass ▪ Aluminum ▪ Galvanized Steel ▪ Most Rigid to Semi-Rigid Plastics ▪ Sanded OEM Paint
PREPARATION: • Clean and degrease the entire panel to be repaired with soap and water, followed by a mild cleaning solvent. Thoroughly dry the surface before repairing. • Use 80-180 grit to remove or scuff the paint and featheredge. MIXING: • Place the desired amount of material on a clean, non-fibrous surface. Knead the cream hardener before use. • Measure hardener 2% by weight (add a ribbon of cream hardener from edge to edge across the center of a 4” (10 cm) diameter puddle. Puddles larger than 4” in diameter will require additional hardener. • Mix thoroughly until uniform color is achieved. • Approximate setting time is 4 - 5 minutes @ 72°F (22°C)
APPLICATION: • Spread a thin layer of mixed material over surface using firm pressure. • Apply additional layers to build material slightly higher than the surface to allow for sanding to desired contour NOTE: Do not apply over new or uncured coatings. Avoid thick heavy applications.
FINISH: • Sand to contour with 180 grit sandpaper. • Final sand with 180 grit followed by 220-320 grit if desired. TOPCOAT: • Apply 2K polyester, 2K urethane, 2K epoxy, or 1K primer to manufacturer’s recommendations.
